Site B: the MSS is configured to 1380 bytes (default) on WAN I tried to set the MSS to 1380 (ipv4) on the WAN interface to use the fW scrubber RSYNC still stalls and fails after 10-20 minutes. I tried syncing just a dozen of 2GB files. Same for Hyper Backup, backing up large amount of data. I need to restart the RSYNC and it lasts again 10-20 min and stalls. I can still reach the Syno NAS on Site B without issues. When I'm rsyncing data in between the Syno NAS, the traffic maxes out the internet upload throughput for 10-20 minutes and then the trafic stalls and drops to low kb/sec. The whole setup works fine except for the IPSec tunnel. I replaced ASA 5506-X on site A with an OPNSense VM on libvirt. I never had issues rsyncing huge amounts of data both ways maxing out the internet egress throughput at 50mbps.Former setup ASA5506-x to ASA 5505 IPSec tunnel.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |